Step 6. Test The Installation - HP Scanjet N6010 Guide D'installation

Chapter 1

Step 6. Test the installation

Caution
does not contain wet glue, correction fluid, or other substances that can be
transferred to the interior of the scanner.
Make sure there are no curls, wrinkles, staples, paper clips, or any other attached
material. Sheets should not be stuck together.
1. Place a single page in the document feeder. The page should be face down, with
the top of the page pointing down ( ).
2. Adjust the paper guides. The paper guides must be touching both sides of the page
to work properly. Ensure that the page is straight and that the guides are against the
edges of the page.
Note
3. Press the Scan to PDF (
The page will feed through the scanner. A scan of the page should appear on your
computer screen in the PDF viewer. This confirms that the installation was
successful.
Note
program installed in order to successfully complete this process. If you do
not have a PDF viewer, run this test using the Scan Document button.
If a scan of the page does not appear on your computer screen, see Troubleshooting
on page 18.
10
Before placing an item in the document feeder, make sure that the item
To adjust the paper guides, press on the lower part of the guide.
) button.
You must have Adobe Acrobat Reader or another PDF-viewing
HP Scanjet N6010 Sheetfeed Document Scanner