Charging The Battery; Cbj Home Control Unit; Cbj Care, Cbj1, Cbj2 Control Unit; Battery Indicator - Invacare Birdie EVO Manuel D'utilisation

Birdie® EVO and Birdie® EVO PLUS / XPLUS
1. Locate the red
emergency grip A
at the bottom of the
actuator piston.
2. Slowly pull up the red
emergency grip A and
hold it in position when
a safe lowering speed
is reached.
3. If no lowering occurs
with a fully pulled
emergency grip A,
push down on the
boom at the same
time.
The effective lowering speed is depending on the patient
weight. If the speed is too low or too high, it can be adapted
to the patient weight.
Adjusting the lowering speed:
1. Locate the screw in the bottom hole of the red
emergency grip A.
2. Turn the screw counter-clockwise to increase the speed.
3. Turn the screw clockwise to decrease the speed.
Birdie® EVO COMPACT
(optional)
1. Locate the emergency
release knob A at the
top of the actuator
piston.
2. Rotate the emergency
release knob A
clockwise.

5.7 Charging the battery

IMPORTANT!
– Make sure the emergency stop is not activated
while charging the battery.
– Make sure that charging takes place in a room
with good air ventilation.
– Electrical functions are not working when the
lift is connected to power supply.
– Do not attempt to use the lift if the battery
housing is damaged.
– Replace a damaged battery housing before
further use.
– Do not move the lift without unplugging from
the power outlet.
It is recommended to charge the battery daily to ensure
optimal use of the lift and prolong the life of the battery.
Furthermore, it is recommended to charge the battery
before first use.

5.7.1 CBJ Home control unit

The control unit is equipped with a sound signal. A beep
indicates that the battery has low capacity, but lowering the
1650023-F
patient is still possible. It is recommended to charge the
batteries as soon as the sound signal is heard.
1. Plug the power cord C into a power outlet.
The battery will charge in approximately 4
hours. The charger stops automatically when the
batteries are fully charged.
The upper yellow diode A will flash during
charging, and switch to continuous light when
fully charged.
The lower green diode B will light continuously
while the control unit is connected to the
mains, and lights up when any button on the
hand control is pressed or when the electric
emergency lowering is activated.
2. Disconnect the power cord from the power outlet after
the battery has been fully charged.

5.7.2 CBJ Care, CBJ1, CBJ2 control unit

The control unit is equipped with a sound signal. A beep
indicates that the battery has low capacity, but lowering the
patient is still possible. It is recommended to charge the
batteries as soon as the sound signal is heard.
1. Plug the power cord A into a power outlet.
The battery will charge in approximately 4
hours. The charger stops automatically when the
batteries are fully charged.
The right yellow diode B will light continuously
during charging, and switch off when fully
charged.
The left green diode C will light continuously
while the control unit is connected to the mains.
2. Disconnect the power cord A from the power outlet
after the battery has been fully charged.

Battery Indicator

The control unit may be equipped with a battery indicator
D, indicating the remaining battery capacity.
Usage
15