Charging The Battery - Invacare Birdie Manuel D'utilisation

Masquer les pouces Voir aussi pour Birdie:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
Fitting the sling
Slings designed for 2- or 4-point spreader bars can be used with this mobile hoist, please refer to
Invacare
's sling brochure for details.
®
Note: The size of the sling and the width of the spreader bar should correspond.
1. Choose the most appropriate sling for the patient. The carer must be trained in the use of hoists
before performing any transfers.
2. Carefully inspect the hoist and the sling. If defective parts are found, the damaged parts must be
replaced.
3. Only use slings suited for the hoist and the patient.
4. Place the patient in the sling as described in the sling manual. Pay special attention to the fact that
the sling is correctly applied.
5. Lower the jib and mount the straps of the sling. If the patient is in a sitting position, the jib must be
lowered to chest height and the hoist must be moved as close as possible to the patient.
6. Make sure that there are no obstructions when raising the jib. Ensure that brakes are not engaged
before lifting or lowering.
Caution! Do not lift or lower a patient with the brakes applied. Always let the hoist find the
correct centre of gravity. Make sure that the lifting area is between the legs of the hoist.
Never operate the hoist when the patient is outside the base and leg area. Always be careful
when lifting or lowering a patient. Never exceed the maximum recommended lifting capacity.

Charging the battery

The hoists are equipped with an internal charger. It is recommended to charge the batteries regularly to
ensure optimal use of the hoist and prolong the life of the batteries. Furthermore, it is recommended to
charge the batteries before first use.
The control unit is equipped with a sound signal, which will beep when operating with low battery
capacity.
It is recommended to charge the batteries as soon as the sound signal is heard.
How to charge the batteries:
1. Connect the mains cable to the control unit and plug it in. It takes about 4 hours to charge
the batteries. Charging must take place in a room with good air ventilation. The charger stops
automatically when the batteries are fully charged.
2. Remember to disconnect the charger cable before using the hoist again.
The emergency stop must not be activated - otherwise it will be impossible to charge
the batteries. While charging takes place the hoist cannot be used. Do not use or move
the hoist without unplugging from the socket outlet. Do not attempt to use the hoist if the
battery housing is damaged. Replace a damaged battery housing before further use.
12

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Birdie compact

Table des Matières