Table des Matières
Publicité
EN
•
Ensure the wheelchair fits safely on the platform, and
doesn't extend over the edges of the platform, nor doesn't
interfere with the automatic roll-stop at the rear, nor the
bridge plate at the front of the platform.
•
When exiting the vehicle, never back onto the platform.
Always face outward, ensure the platform is safely in
place at the loading floor of the vehicle, the side safety
rails are locked into position, and the automatic roll-stop is
up and locked into position.
Use extreme care in wet or slippery conditions. Wheel-
•
chair brakes are less effective if the platform and / or
wheels of the wheelchair are wet or dirty.
•
Ensure the passengers take a central position between
the lift arms. [See Fig. 5.11].
•
If available, the platform occupants should
grip both side safety gates. [See Fig. 5.12 -
5.13]
§5.5 - Loading diagram
•
Hydraulic lifts are not designed to LIFT / LOWER weights
corresponding to their nominal capacity over the full sur-
face of the platform. The nominal capacity is valid at a
centre of gravity of 500mm behind the vehicle body.
Behind that point, the maximum safe working load dimin-
ishes.
•
When LIFTING, the lift is normally protected against over-
load by the pressure relieve valve in the hydraulic circuit.
DHOLLANDIA
5.11
5.12
A43
5.13
Publicité
Table des Matières
