With Function "Safe Torque Off" Deactivated - Lenze 9300 vector Instructions De Montage

5 Electrical installation
Control terminals

With function "Safe torque off" deactivated

5.6.3 With function "Safe torque off" deactivated
)
Note!
If the function "Safe torque off" is not made use of, the safety relay K
be energised permanently to ensure the tension supply of the power output
stage.
Supply via internal voltage source
If a freely assignable digital output (e.g. X5/A1) is assigned permanently to HIGH
ƒ
level, it serves as an internal voltage source. Every output has a maximum load
capacity of 50 mA.
– The relay K
voltage via a digital output.
– Two digital outputs must be connected in parallel and assigned permanently to
HIGH level in order to obtain the maximum wiring (relays K
X5/ST1).
For the supply of the analog inputs (X6/1, X6/2 and X6/3, X6/4) you have to set a
ƒ
freely assignable analog output (e. g. X6/63) permanently to HIGH level.
+5 V
+
K
SR
X11 K31 K32 33 34 X5 28 E1 E2 E3 E4
S1
Fig. 5−18
100
and two digital inputs (X5/28 and e.g. X5/E1) can be supplied with
SR
GND2
E5 39 A1
Wiring of digital and analog inputs/outputs with function "Safe torque off" deactivated, given an
internal voltage source
S1 Controller enable
NO contact or NC contact
Load
Z
Minimum wiring required for operation
Terminal assignment in the Lenze setting: ^ 102
l
+24V
1
2
3
X3
4
5
6
A2 A3 A4 ST1ST2 59
X6
must
SR
and X5/E1 ... X5/E5,
SR
GND1 GND1
242R
3.3nF
3 7 62 63
1 2 4
AOUT2
AIN1 AIN2 AOUT1
1 2 3 4 7
AOUTx
10k 10k
9300vec0137
EDKVF9383 DE/EN/FR 4.0
7