Internal Display; Measurement Display Mode - Nikon Coolshot 40i Manuel D'utilisation

5. Internal display

En
Es
Fr
Incline
Pt
Decline
First Target Priority mode
Distant Target Priority mode
: Aim at the target you want to measure. Position the target at the center of the reticle.
: Appears while the laser is being irradiated for a measurement.
Do not look towards the objective lens side while this mark is shown.
: Now measuring
: "Failure to measure" or "Unable to measure"
* Because the internal display of this product is enlarged by the eyepiece, dust may sometimes be seen.
This will not, however, affect the measurement accuracy.
10
Distance
Unit of measure (m/yd.)
Target mark
Laser irradiation mark
Height
(Actual distance at Golf mode setting)
Battery condition

6. Measurement display mode

Actual Distance
and Height Mode
Horizontal Distance
and Height Mode
Golf Mode
* (Horizontal distance ± Height)
Actual Distance
Mode
1. Turn on the power.
Actual
Distance 2. Press and hold the MODE button, then
immediately press the POWER ON/
Height
Measurement button.
3. Release your finger from the POWER ON/
Measurement button within 2 seconds to
switch the Measurement display mode.
Horizontal 4. Repeat steps 2 and 3 to switch measurement
Distance
display mode in rotation.
* If the buttons are not pressed in the correct
Height
order, switching will not take place.
Slope Adjusted
Distance*
Actual
Distance
Actual
Distance
En
Es
Fr
Pt
11