Measurement - Nikon Coolshot 40i Manuel D'utilisation

10. Measurement

En
Caution — Controls, adjustments or usage of procedures other than those specified herein may
produce negative effects or damage to your health due to laser radiation.
Es
Fr
1. Preparing
Pt
Install a battery in the battery chamber. (See "Battery")
2. Diopter adjustment
Adjust the diopter to obtain a clear internal display in the viewfinder.
First, rotate the diopter adjustment ring counterclockwise until it comes to a complete stop. Next, rotate the
diopter adjustment ring back and forth until the internal display comes into focus.
3. Measuring
Before measuring, be sure to confirm each mode (Measurement display mode/Target priority mode/Distance
display unit) setting.
* Please refer to each section on how to set each mode.
3-1. Turn on the power.
(Automatic power shut-off after
approx. 8 seconds unoperated.)
Immediately after power-on Standby
14
3-2. Aim at the target.
Position the target at the center of
the target mark.
3-3. Press the POWER ON/Measurement button to start measurement.
After measurement, the result is displayed for approx. 8 seconds, then power automatically turns off.
If you press the POWER ON/Measurement button during power-on, another measurement starts.
Example of measured distance
display
* Continuous measurement function
Press and hold the POWER ON/Measurement button to start continuous measurement up to approx.
8 seconds. During measurement, the measured result is displayed consecutively while the laser
irradiation mark is blinking.
If you release your finger from the button, continuous measurement stops.
When measuring a flagstick at a golf course, for example, set First Target Priority
mode. Keep targeting the flagstick at the center of the target mark with the
continuous measurement function to minimize handshake.
Example of measurement failure
En
Es
Fr
Pt
15