Continuous Measurement Mode - Nikon Forestry Pro Manuel D'utilisation

※ See the the chapter "External and Internal display" for details
regarding the operations and results display of the various
modes."
＊ Power turns off 30 seconds after the last operation.
☆【Continuous measurement mode】
Keeping the POWER button depressed allows you to
perform continuous measurement for 20 seconds.
Blinks while performing measurements.
When measuring a pin at a golf course, for example, use First
Target Priority and Continuous measurement mode for easy
measurement. With no objects between you and the pin, the
smallest number is the distance to your targeted pin.
5. Selecting display unit (Factory default setting is feet.)
Meter
[ ]
1. Confirm the LCD panel is on.
2. Press and hold the
3. When display unit has switched, release the
4. Repeat steps 2 and 3 until your desired mode is displayed.
5. When you have completed setting, results will be converted
and displayed in the your selected measurement unit.
[ ]
Yard Feet
[ ]
button for approx. two seconds.
button.
6. Switching measurement/display modes (Factory default
setting is linear distance measurement mode)
Linear Distance [
Height [ ]
Vertical Separation
(height between 2
[ ]
points )
By pressing the MODE button, modes will change in the order
indicated above.
1. Confirm the LCD panel is on.
2. Press button within 0.5 seconds.
3. Release button to switch the mode.
4. Repeat steps 2 and 3 until your desire mode is displayed.
5. Switching the mode after measurement converts the
results to the new mode.
6. After the mode is set, measurements are performed in the
new mode.
Horizontal Distance [
]
Angle [ ]
Three-point measurement
[ ]
En
De
]
Fr
Es
It
Ru
No
Se
Fi
Nl
Dk
Ro
Pl
Hu
Cz
15