Changing Batteries - Nikon Forestry Pro Manuel D'utilisation

Changing Batteries

• Type of battery: 3V CR2 lithium battery
• Battery condition indicators
:
:
flashing:
disappears:
flashing in the LCD indicates that the battery should be replaced.
1 Open the battery chamber cover
Using the ball of the thumb or a coin in the recessed part of the battery chamber cover, rotate the cover following the Open/
Close arrow indicator. It may not open easily due to its rubber packing for water resistance.
2 Replace the old battery with a new one
Install new battery with the [+] and [-] correctly positioned following the "Battery installation" indication seal in the battery
chamber. (Insert battery positioning the [+] pole towards the inside of the chamber.) [The Laser Forestry Pro will not operate
if the battery is installed incorrectly.]
3 Close the battery chamber cover
Align the Open/Close indicator with the white dot and insert the battery chamber cover. Using the ball of the thumb or a
coin, turn the cover in the opposite direction to the arrow indicator. It may not close easily due to the rubber packing for
water resistance, but continue to turn it all the way until it stops. Confirm that the cover is securely closed.
• Battery life
Continuous operation: Approx. 13,000 times (at 20°C)
Target focusing, measurement, and automatic power off are included in a single cycle. This figure may differ according to
temperature, and other factors such as target shape, colour, etc.
* The Nikon Laser Forestry Pro come with a 3V CR2 lithium battery. However, due to natural electric discharge, the life of the battery will likely be
shorter than that noted above.
* Replace battery if the Nikon Laser Forestry Pro is ever submerged in water or if water enters in the battery chamber.
Battery has enough power for use.
Battery is getting low.
Battery is low and battery should be replaced.
Battery is exhausted and should be replaced.
En
De
Fr
Es
It
Ru
No
Se
Fi
Nl
Dk
Ro
Pl
Hu
Cz
11