Internal Display - Nikon PROSTAFF 3i Manuel D'utilisation

Internal display

En
Es
Fr
Pt
Horizontal Distance mode
First Target Priority mode
Distant Target Priority mode
: Aim at the target you want to measure. Position the target at the center of the reticle.
: Appears while the laser is being irradiated for a measurement.
Remains present during single measurement. Blinks during continuous measurements.
Do not look towards the objective lens side while this mark is shown.
: Now measuring
: "Failure to measure" or "Unable to measure"
* Usually, an LCD employs equal or lower magnification. However the LCD of this product is magnified
by the high magnification of the eyepiece. Although this LCD was produced using the most advanced
technology, it is impossible to eliminate dust completely. As a result, dust may be seen. It will not,
however, affect measurement accuracy or safety during use.
10
Distance
Unit of measure (m/yd.)
Target mark
Laser irradiation mark
Battery condition