Single Measurement - Nikon PROSTAFF 3i Manuel D'utilisation

【 Single measurement 】
3. Press the POWER ON/
Measurement button once to
start single measurement.
Measuring
【 Continuous measurement function 】
3. Press and hold the POWER ON/Measurement button to start continuous
measurement for approx. 8 seconds. The internal display shows
"measured distance" and "fail to measure" indicator alternately.
* The laser irradiation mark blinks during the measurement.
* If you release your finger from the button, continuous measurement
stops.
Displays the
measured figure
measured figure
(Target 1)
Displays the "Failure to measure" or
"Unable to measure"
(Target 2)
distance
4. After measurement, the "measured distance" or "fail to measure" indicator
is displayed for approx. 8 seconds, then power turns off. If you press the
POWER ON/Measurement button during power-on (while the internal
display is on), another single measurement starts.
Displays the measured figure
4. After continuous measurement, the results of final
measurement (measured distance) is displayed for approx.
8 seconds, then power turns off.
If you press the POWER ON/Measurement button during
power-on (while the internal display is on), another
measurement starts.
"Failure to measure" or "Unable
to measure" distance
En
Es
Fr
Pt
15