Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
1. Light-Tracking Mode
To activate the light-tracking mode, set the Mode button to L. Press the
transmitter button corresponding to the selected collar once (briefly).
The tracking light will now blink every 3 seconds.
To turn the tracking-light off, press the transmitter button corresponding
to the selected collar for more than two seconds.
While the tracking-light function is on, you can use the other functions
(Nick, Constant, Pager) at the same time. However, if the Light-locate
mode is activated, this will automatically switch off the Light-tracking
mode.
In any situation, the Light-Tracking mode can be turned back on by
placing the mode button to L and pressing the transmitter button for a
short time.
2. Light-Locate mode
To activate the light-locate mode, shift the mode button to L. Press the
transmitter button corresponding to the selected collar and hold it down.
The LED light blinks rapidly as long as you hold the button down, for a
maximum time of 12 seconds.
* When the Light-Tracking mode is on, the Tracking mode will
automatically be turned off after the Light-Locate mode action.
46
L (Light)
The LED light of the 4500
EDGE receiver collar has
two functions: Interval Light-
Tracking and Light-Locate
mode.
The buttons on the front of the transmitter enables
control of up to 4 receivers/collars. Each of the 4
buttons on the transmitter can be coded to operate a
different receiver/collar. The receivers/collars can be
distinguished by coding the transmitter button to the
matching receiver/collar strap color.
Additional receivers/collars with straps are available
by calling customer service at +33(0)1 30 62 65 65.

3. COLLAR FITTING

The collar should be fit so that the surgical stainless steel contact points
are pressed firmly against the dog's skin. With a proper fit, you should
be able to insert a finger or two snugly in between the contact points
and your dog's skin. The best location for the receiver box is on either
side of the dog's windpipe. The receiver box should stay in this position
during any training or exercise. If the unit slips downward towards the
dog's windpipe, the unit was NOT fastened firmly enough.
A loose fitting collar can cause the contact points to rub against the
skin and cause irritation. If the collar is on too tight, the dog may have
difficulty breathing. ALWAYS check your dog's neck for signs of skin
irritation when using an e-collar. If any signs of skin irritation are found,
suspend e-collar training and consult with a veterinarian.
47

Publicité

Table des Matières

Dépannage

loading

Table des Matières