Code Setting; How To Change The Length Of The Contact Points - Dogtra 4500 Edge Notice D'utilisation

11. CODE SETTING

To set the coding for the Dogtra 4500 EDGE transmitter to an existing
receiver/collar, or an Additional receiver/collar, follow the steps below.
*Attention: Turn the mode selection dial to "P", or "L", to check that
unit has been coded properly.
54
1. Start by turning on the transmitter
by holding down the on/off button
on the back of the transmitter.
2. Set the transmitter's intensity dial
to "0", and the mode selection dial
to "C".
3. In the off position hold down the
receiver/collar on/off button until
the green LED indicator light
begins to blink rapidly.
4. Immediately press the button on
the transmitter of the color you
would like the receiver/collar to be
coded to.

12. HOW TO CHANGE THE LENGTH OF THE CONTACT POINTS

The Dogtra 4500 EDGE comes equipped with standard 15mm contact
points that can be extended to 19mm contact points, for use with dogs
with longer coats.
To increase the contact point length from 15mm to 19mm, follow the
steps below.
1. Using the included adjustment tool with the side marked 5/8",
unscrew the contact points counter-clockwise.
2. Place the contact point extension over the exposed threads, flat side
down.
3. Place the contact points over the extensions and tighten the contact
points and extensions clockwise using the adjustment tool with the
side marked 3/4".
* Caution: Tighten until firmly in place. Be careful not to over tighten.
To shorten the contact points back to the standard 15mm, start with the
adjustment tool with the side marked 3/4", remove the contact point
extensions, and tighten the contact points with the adjustment tool with
the side marked 5/8".
55