Code Setting - Dogtra IQ Plus Duo Manuel D'instruction

Warning
1. Fully charge the unit before using it for
the first time.
2. Do not charge the batteries near any
flammable substances.
3. Fully charge the batteries if the unit is
to be stored without use for a period of
one month or more.
4. Always use Dogtra approved chargers.
If improper chargers are used, the LED
will flash in amber or may not light up
at all.
48
7. CHARGING THE BATTERY
Chargeur info
Manufacturer : HON-KWANG
Manufacturing country : CHINA
Model name : HK-AP-050A100-EU
INPUT : 100~240V~50/60Hz 0.2A /
OUTPUT : 5V 1.0A
ATTENTION
!
During battery charging, the unit must
be close to the wall outlet and the wall
outlet must be easily accessible for
security reasons.

8. Code Setting

1-Dog code setting
1. Start with the receiver/collar turned off
and the Rheostat intensity dial level on
the handheld transmitter set to "0".
On the handheld transmitter, slide the
dog selector switch left to align with "I".
2. Place the red dot on the back of the
handheld transmitter to the red dot on
the receiver/collar. Hold the two red
dots together for 5 seconds.
Release them when the green LED
blinks rapidly on the receiver/collar.
3. With the handheld transmitter,
press the Nick and Constant buttons
simultaneously. The code setting has
been successfully done if the receiver/
collar vibrates when the pager button is
pressed on the handheld transmitter.
2-Dog code setting
1. Start with the receiver/collar
turned off and the Rheostat intensity
dial level on the handheld transmitter
set to "0". On the handheld transmitter,
slide the dog selector switch right to
align with "II".
8. CODE SETTING
49