Collar Fitting - Dogtra iQ MINI Mode D'emploi

1st Dog 2nd Dog
44
1st Dog/2nd Dog Toggle Switch
The 1st Dog/2nd Dog Toggle Switch is
on the left of the Rheostat Dial.
I - 1st Dog
Slide the switch to the left underneath
"I" and press any of the buttons to
operate the first receiver/collar.
II - 2nd Dog
Slide the switch to the right underneath
"II" and press any of the buttons to
operate the second receiver/collar.

3. COLLAR FITTING

Proper Fit
The collar should be fitted so that the
conductive plastic contact points press
firmly against the dog's skin. You should
be able to fit a finger in between the
contact points and your dog's skin. The
best location is on either side of the dog's
windpipe.
Improper Fit
A loose fit can allow the collar to move
around on the dog's neck. When this
happens, the contact points may rub
against the skin and cause irritation. If the
collar is too loose, the contact will not be
consistent and cause the corrections to
be inconsistent.
45