Extraordinary Maintenance; Problems - Failure To Sedate The Patient - Tecno-gaz MasterFlux Smart Mode D'emploi

8.3

EXTRAORDINARY MAINTENANCE

THE DEVICE MUST UNDERGO A FUNCTIONAL AND ELECTRICAL SAFETY CHECK
(ELECTROMEDICAL EN 62353).
THE RECOMMENDED FREQUENCY OF SAFETY INSPECTIONS IS ONCE A YEAR FOR
EQUIPMENT USED IN SURGICAL AND SIMILAR PREMISES AND ONCE EVERY TWO YEARS FOR
EQUIPMENT USED IN ALL OTHER TYPES OF PREMISES SUCH AS DENTAL PRACTICES.
THE ELECTRICAL SAFETY CHECK MUST ALWAYS BE CARRIED OUT AFTER REPAIR WORK ON
THE EQUIPMENT.
CONTACT TECHNICAL SUPPORT TO BOOK AN INTERVENTION.
8.4

PROBLEMS - FAILURE TO SEDATE THE PATIENT

Possible causes
The mask does not adhere to the
patient's face.
The correct % of N O was not
2
determined.
The one-way valves on the mask are
damaged or the membrane is missing.
The patient does not sedate.
Active suction is excessive and takes
up the gas before it is taken up by the
patient.
The circuit and/or the anaesthesia bag
are damaged.
Leakage of the emergency suction
valve.
The anaesthesia bag inflates until it
detaches from the hose connection.
Use a mask with a size suitable for the patient.
BASELINE is characteristic of the patient, it is important to
assess the characteristic parameters that indicate that the
patient is sedated.
Replace the mask.
Instruct the patient to breathe through the nose.
Check, the behaviour of the anaesthesia bag, it must remain
open and follow the patient's breathing
If necessary, reduce the suction flow.
Small cuts or cracks may allow gas to escape and not reach
the patient.
Replace the damaged component.
Set an oxygen flow.
Close the delivery hose connection (see paragraph 6.1
position A) with one hand and check that the balloon
inflates.
Remove your hand and stop the flow.
If any leaks are noticed, contact the Tecno-gaz service
centre.
The gas supply pipe to the patient was reversed with the
exhaled gas pipe
32 - 33
Solution
ENGLISH