Building A Ring - Sagem ADR 155C Guide D'installation Et D'utilisation

5.7

Building a ring

This section describes (using an example) the interface IP configuration for a ring network.
For each equipment, you can configure the Ethernet port, the Equipment address and four PPP (Point to Point Protocol) software ports from
PPP1 to PPP4. For each PPP software port, you can assign one of five physical ports corresponding to the MNGT port and to slots A, B, C and D, and two
channels VC12 referenced P#1 and P#2.
Example :
!
The three ADR155c equipments can be operated using a web browser. The management links are secured by the RIP protocol.
!
Refer to the section Connecting to an ADR155c for operation of the equipment using the web browser.
No reproduction or communication without the written consent of SAGEM SA
Sub-network: 135.11.110.8
IP parameters
@IP : 135.11.110.9
Mask : 255.255.255.252
@Gateway : 135.11.110.10
5 – STARTUP GUIDE
! Refer to section "Connecting to an
ADR155c to configure the Ethernet
port and the Equipment address of
each rack.
! Refer to the section "Configuring a
PPP port" to configure the PPP ports
of each equipment.
Installation and User Guid - N56717020104
Page A5-13