Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1 - INSTALLATION AND COMMISSIONING
1.3.5 - Connecting on ADR LAN1 card
ADR LAN1
STATUS
LED
Green Red
ON
OFF
ON
ON
OFF
OFF
OFF
ON
Flashing
Figure 1-6 – Connecting ADR LAN1 card input
"ETH" Interface :
Port
Connector
Pin N°
1
2
3
4
5
6
7 and 8
NOTE: Two LEDs are linked to the "ETH" interface:
•
Left LED, "Activity"
•
Right LED, "Link"
Electrical characteristics compliant with the IEEE 802.3U
Installation and User Guide - N56717020104
Page A1-18
No reproduction or communication without the written consent of SAGEM SA
STATUS
Card in service
Card in alarm
Hardware default
Card out of service
Autotest default
Traffic Ethernet interface operating at 10 or 100 Mbit/s in half-
duplex or full- duplex mode according to the mode used by the
interlocutor (manual or dynamic adaptation of the Ethernet port on
each new log-in of the interlocutor),
Ethernet 10 or 100 BaseT - RJ48 Type (Shielded RJ45).
Pin 8
Signal name
TX_ETH_TIP
TX_ETH_RING
RX_ETH_TIP
NC
NC
RX_ETH_RING
NC
10
100 HALF
FULL
/
/
ETH
Yellow LED : Ethernet interface type
ON
Yellow LED : Ethernet interface bite rate
ON
Pin 1
Front view
Ethernet output (hot point)
Ethernet output (cold point)
Ethernet input (hot point)
Reserved
Reserved
Ethernet input (cold point)
Reserved
: Traffic status indicator,
: Link status indicator.
HALF/FULL
(Half or Full Duplex)
: Full duplex
10/100
: 100 Mbit/s
Comments
Publicité
Chapitres
Table des Matières
