Configuring A Ppp Port - Sagem ADR 155C Guide D'installation Et D'utilisation

5.3

Configuring a PPP port

A PPP port on an equipment must be configured when extending a network, just as for configuration of the Ethernet port, using the web browser.
In the example below, the instructions are given for configuration of port PPP1. Ports PPP2, PPP3 and PPP4 are configured in the same way
as for port PPP1.
!
Connect the "ETH" access of the equipment to the Ethernet board of the PC using the crossed Ethernet cable RJ45
"
The yellow led of the "ETH" connector of the equipment should come on.
!
Start the web browser
!
In the home screen, complete the "Address" field with the Equipment address (192.168.30.30)
!
The window Welcome on the ADR155C's site is displayed on the screen. By default, there is no password. Click the "Apply" button.
!
The window ADR155C : Shelf view is displayed on the screen.
!
Click on the "ETH" port then on the "Interfaces Configuration" link to configure the PPP1 port of the equipment.
No reproduction or communication without the written consent of SAGEM SA
5 – STARTUP GUIDE
! Click the "Apply" button then
validate the reboot prompt with the
"Restart Now" button.
! After restarting the equipment,
port PPP1 is configured.
Installation and User Guid - N56717020104
Page A5-9