Sagem ADR 155C Guide D'installation Et D'utilisation page 33

The IP address must be different from that of the other equipment.
The default value 000.000.000.000 corresponds to no configuration of the IP address.
When the IP address exists and is modified, equipment REBOOT is proposed.
Error message: "Equipment address is mandatory": the equipment address is mandatory
when at least one PPP link is not numbered.
> Choice "2" : Configuration of Ethernet interface.
The above screen presents an Ethernet communication interface with its characteristics:
"Interface State" : choice of interface state: 0 (Interface off) or 1 (Interface on).
"IP Address" : IP address.
"Subnet mask" : sub-network mask.
"Route Protocol" : protocol: 0 (None), 1 (RIP) or 2 (OSPF)
> Choice "3" : equipment REBOOT.
This command is used to immediately reboot the application and restart with the parameters
already stored in the equipment.
This REBOOT is performed with no impact on the traffic.
> Choice "4" : Logout / Disconnection
Once the parameter definition process is completed, this command closes the current session.
An automatic session exit is performed after a few minutes if no activity is detected (this time
period can be configured using the manager).
No reproduction or communication without the written consent of SAGEM SA
1 - INSTALLATION AND COMMISSIONING
Installation and User Guide - N56717020104
Page A1-27