Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2 - OPERATION
2.2 - General
The ADR155C operation and maintenance are carried out:
-
either directly on the equipment, through the front panel indicator lights and two engineering
management loops (loops A and B),
-
or from a PC fitted with HTTP navigator,
or from a network manager, using the SNMP protocol.
-
-
2.3 - Operational parameters
The operational parameters include:
!
the configuration parameters,
!
the maintenance commands or operations (these actions are cleared in case of power supply
loss)
!
the alarms and their severity.
Configuration parameters
NOTE : The functional blocks naming, configuration parameters and their default value, noted
"XXXXXX", are displayed on HTTP navigator.
Configuration parameters per functional blocks
SPI :
SDH Physical Interface
The Automatic Laser Shutdown function can be disabled
(equipment global functionality)
"ALS" (Automatic Laser Shutdown)
MST : Multiplex section Termination
EBER-B2 monitoring ; configurable in "Monitoring" or "No Monitoring"
If EBER-B2 is not monitoring, AIS, SF and MS-RDI consequent actions are
inhibited
SD-B2 threshold: configurable from 10
"SD-B2 threshold"
SOH : Section OverHead
Configuration of SOH bytes which are not used in standard or for EOW
orderwire conveying. Cconfigurable bytes are :
Line 1, byte of column 7
Line 1, byte of column 8
Line 1, byte of column 9
Line 2, bytes of columns 8, 9
Line 9, bytes of columns 8, 9
Installation and User Guide - N56717020104
Page A2-2
No reproduction or communication without the written consent of SAGEM SA
-5
to 10
Table 2-1 – Configuration parameters (1/8)
-9
Default
value
"enable"
" Monitoring"
-6
"10
"
"01"
"02"
"03"
"00"
"00"
Publicité
Chapitres
Table des Matières
