1 - INSTALLATION AND COMMISSIONING
> Choice "5" : Ping.
"IP Address" : Choice of IP address of equipment to be contacted.
Round trip time in ms
NOTE: The Ping command is used to check the accessibility and the return path from the
remote equipment by testing both the address of the interface and the address of the equipment.
If the address of the port by which the Ping command is generated is different from the address
of the equipment, two commands are generated.
> Choice "6" : Trace route.
"IP Address" : choice of IP address of equipment to be contacted.
Installation and User Guide - N56717020104
Page A1-28
No reproduction or communication without the written consent of SAGEM SA