Repeat Function; Random Playback; Programming Function - TechniSat DIGITRADIO 3 Notice D'utilisation

11.4 Repeat function

You can select whether a track, the entire folder/album or all of the tracks are to be
repeated.
> Press the Repeat
The selected mode appears on the display (Repeat Track 1x, Repeat Album,
Repeat All).
> To switch the function off again, press the Repeat track button as often as
required until the [Repeat off] appears.

11.5 Random playback

With the random generator, the tracks can be played back in a randomly mixed
order.
> If you press the SHUFFLE
display.
> To switch the function off again, press the SHUFFLE button again.

11.6 Programming function

With the programming function, you can play the tracks on a USB medium in an
order determined by you.
You can only undertake the programming if the device is in Stop Mode.
> Press the FAV button on the remote control.
> The Folder Number and the Track Number flash on the display. [P01] appears
to the right of this. P01 is the first programming slot. Any tracks you want can
then be set up in sequence in the programming slots.
> Use the F+ and F- buttons to select the folder where the track that you want
to put in Programme Location 1 is located.
> Use the Previous Track
programmed.
> Press the OK button to accept the track.
> Programming slot 2 (P02) is then active. Proceed as described above to save
a track to programming slot 2. Do this to save the tracks you want to all the
programming slots.
> Press the Play/Pause
In order to add tracks to the current programming, press the Stop
once. You can then place additional tracks in the next unoccupied programme
location.
78
button multiple times.
button while playing, Random appears on the
or Next Track
button to play the programmed tracks.
to select the first track to be
button