Selecting The Source; Adjusting The Volume; Display; Calling Up Visual Displays - TechniSat DIGITRADIO 3 Notice D'utilisation

> Pressing and holding the On/Standby button will put the device in power-
saving mode and the display will switch off. [Power off] appears briefly on the

display.

5.4.3 Selecting the source

> Press the MODE button to switch between the DAB+ (Digital Radio), FM, CD,
Bluetooth, AUX, and USB sources.

5.4.4 Adjusting the volume

> Adjust the volume using the VOL +/- buttons on the remote control or by
rotating the VOL/STANDBY rotary knob on the device.
- Clockwise - louder
- Anti-clockwise - quieter.
The set volume is shown on the display in the form of a bar chart. Also refer to
Section 5.3.4 concerning operation when headphones are connected.
If the volume is completely turned down (Mute), the device will switch to
standby mode after approx. 15 minutes.
5.4.5 Display
Depending on the selected function or option, the display will show the following
information:
Station name,
Frequency,
Menu name
Display,
Menu options,
Volume

5.4.6 Calling up visual displays

> Press the MENU button and use the < or > buttons to select the [Display]
submenu. Then press the OK button. Select an option using the <, > and OK
buttons. You can choose to have the following information displayed:
In DAB+ mode (the selected function is identified with an "*"):
[Running text] (continuous text with additional information that may be
provided by broadcasters), [Signal intensity], [Channel type], [Ensemble],
[Frequency], [Signal quality], [Bit rate and Codec], [Time] and [Date].
In FM mode (the selected function is identified with an "*"):
[Radio text] (if transmitted), [Channel type] (PTY), [Ps] (Programme Service
Name or Station Name or Frequency), [Audio Information], [Time] and [Date].
64
CD and USB
Ladezustand
Playback:
des Akku
Folder number,
track number,
Track run time