Quick Search; Repeat Function; Random Playback; Programming Function - TechniSat DIGITRADIO 3 Notice D'utilisation

10.5 Quick search

While the track is playing, you can perform a quick search forwards or backwards to
find a specific section.
> Hold down the Previous Track
forwards or backwards within a track for as long as the button is held down.

10.6 Repeat function

You can select whether a track, the entire folder/album (only for mp3 CDs) or all of
the tracks on the CD are to be repeated.
> Press the Repeat
The selected mode appears on the display (Repeat Track 1x, Repeat Album,
Repeat All).
> To switch the function off again, press the Repeat track button as often as
required until the [Repeat off] appears.

10.7 Random playback

With the random generator, the CD tracks can be played back in random order.
> If you press the SHUFFLE
display.
> To switch the function off again, press the SHUFFLE button again.

10.8 Programming function

With the programming function, you can play tracks on a music CD or an MP3 CD in
an order that you determine yourself.
You can only perform programming if there is a disc inserted and the device is
in Stop Mode.
> Press the FAV button on the remote control.
> The Folder Number and the Track Number flash on the display. [P01] appears
to the right of this. P01 is the first programming slot. Any tracks you want can
then be set up in sequence in the programming slots.
> Use the F+ and F- buttons to select the folder where the track is located that
you want to put in Programme Location 1.
> Use the Previous Track
programmed.
> Press the OK button to accept the track.
> The programming slot 2 (P02) is then active. Proceed as described above to
save a track to programming slot 2. Do this to save the tracks you want to all
the programming slots.
or Next Track
button multiple times.
button while playing, Random appears on the
or Next Track
buttons to quickly skip
to select the first track to be
DE
EN
FR
NL
75