Performing A Full Scan; Selecting The Station; Saving Dab+ Stations To A Memory Slot - TechniSat DIGITRADIO 3 Notice D'utilisation

7.2.1 Performing a full scan

The automatic scan "Full scan" scans all DAB+ Band III stations and thereby
finds all stations being broadcast within the reception range.
After the scan is complete, the first station is played back in alphanumeric
order.
> In order to perform a complete scan, open the menu by pressing the MENU
button and use the <, > and OK buttons to select the menu item [Complete
Scan]. Alternatively, press the SCAN button on the remote control.
> [Scanning...] appears on the display.
During the scan, a progress bar and the number of stations found is displayed.
If no station is detected, check the telescopic antenna and, if required, change
the installation location (Section 5.3.3 / 3.2.1).

7.2.2 Selecting the station

> By pressing the P+ or P- buttons, the station list can be called up and you can
switch between the available stations.
Depending on the setting under MENU > Station change, you must then press
the OK button to play the selected station (option: Station change > List) or
the station is played automatically (option: Station change > Channel).

7.2.3 Saving DAB+ stations to a memory slot

The programme memory can save up to 20 stations within the DAB+ range.
> First select the desired station (see section 7.2.2).
> In order to store this station on a memory slot, hold down the FAV button
during playback until [Favourite memory] appears in the display. Then use
the <, > buttons to select a favourite memory slot (1...20). Press the OK button
to save.
> Repeat this process to save additional stations.
You can also save stations to one of the numeric keypad keys by holding
down the corresponding button a little longer. The same applies to the direct
selection buttons on the device.
DE
EN
FR
NL
67