Playing Cds; Selecting The Track - TechniSat DIGITRADIO 3 Notice D'utilisation

10.3 Playing CDs

> Switch to CD player mode by pressing the MODE button.
> [CD] is shown on the display.
> Carefully insert the CD with the labelled side facing upwards. Ensure that the
CD is not positioned at an angle. The CD is automatically drawn in by the
device.
> The data on the CD is scanned. [Reading] appears in the display. Playback
then begins with the first track (audio CD) or the first track in the first folder
(MP3 CD).
Do not perform any operation until the CD content has been completely read,
to ensure that all the required information on the CD has been read. With MP3
CDs in particular, this process can take some time.
When inserting/removing the CD, please hold it by the edge.
> By pressing the Play/Pause
time flashes on the display), or continue playback by pressing it again.
> Use the Stop
on the display.
Always stop the playback prior to removing the CD.
If there is no playback, the DIGITRADIO 3 switches to standby after 15
minutes.

10.4 Selecting the track

> If required, select the categorisation or folder, and the subfolder it contains,
until you reach the track you want in order to play it.
> Folders/albums can be selected using the F- or F+ buttons on the remote
control.
> Use the Previous Track
previous track.
The display shows the folder ([F]) and track ([T]) number set in each case.
74
button, you can pause playback (the playing
button to stop playback. The total number of tracks appears
or Next Track buttons to skip to the next or