Removing/Installing Back Upholstery; Removing Back Upholstery; Installing Back Upholstery - Invacare Patriot Manuel De L'utilisateur Et D'entretien

SECTION 7—SEAT/BACK

REMOVING/INSTALLING BACK UPHOLSTERY

NOTE: For this procedure, refer to FIGURE 7.2.

REMOVING BACK UPHOLSTERY

1. Rotate the flip back arms up and out of the way. Refer to Adjusting/Using Armrest on
page 36.
2. Cut the tie wraps that secure the back upholstery to the wheelchair frame.
3. Remove the two (2) mounting screws and washers that secure the existing back
upholstery to the back canes.
4. Remove the one (1) mounting screw and locknut that secures one (1) back cane to the
wheelchair frame.
5. Pull the loose back cane out of the existing back upholstery.
6. Slide the existingback upholstery up and over the mounted back cane.
7. Install the new/existing back upholstery. Refer to Installing Back Upholstery on
page 40.
INSTALLING BACK
UPHOLSTERY
1. Install new/existing back upholstery
over the mounted back cane.
2. Slide the loose back cane through the
new/existing back upholstery.
3. Using the mounted back cane as a
reference, position the loose back cane
at the same height.
4. Secure the back cane to the wheelchair
frame with the one (1) mounting screw
and locknut.
5. Secure the new/existing back
upholstery to the back canes with the
two (2) existing mounting screws and
washers.
6. Secure the new/existing back
upholstery to the wheelchair frame
with the tie wraps.
7. Rotate the flip back arms down. Refer to Adjusting/Using Armrest on page 36.
Patriot™
Mounting
Screw
Back
Cane
Locknut
Mounting
Screw
Wheelchair Frame
FIGURE 7.2 - REMOVING/

INSTALLING BACK UPHOLSTERY

40
Back
Cane
Washer
Back
Upholstery
Part No 1088909