Removing/Installing Heel Loops; Removing Heel Loops; Installing Heel Loops - Invacare Patriot Manuel De L'utilisateur Et D'entretien

2. Remove the hex screw and coved spacer and slide the footrest up or down on its
mounting tube until the desired footrest height is achieved.
3. Reassemble the hex screw and coved
spacer through the footrest upper
support and mounting tube as shown
in FIGURE 5.2.
4. Securely tighten the hex screw and
coved spacer.
5. Install the footrest assembly onto the
wheelchair. Refer to Installing/
Removing Swingaway Footrest on
page 30.
6. Repeat STEPS 1-5 for the opposite side
of the wheelchair, if necessary.

REMOVING/INSTALLING HEEL LOOPS

NOTE: For this procedure, refer to FIGURE 5.2 and FIGURE 5.3.

REMOVING HEEL LOOPS

1. Remove the hex screw and coved spacer that secure the mounting tube to the footrest
upper support as shown in FIGURE 5.2.
2. Remove mounting tube and footrest from the footrest upper support.
3. Remove the mounting screw, spacer and locknut that secure the existing heel loop to
the mounting tube and footplate as shown in FIGURE 5.3.
4. Slide existing heel loop up to remove from the mounting tube.
5. Repeat STEPS 1-4 for opposite side, if necessary.
6. Install the new heel loop. Refer to Installing Heel Loops on page 31.

INSTALLING HEEL LOOPS

NOTE: For this procedure, refer to FIGURE 5.3.
1. Position new heel loop over mounting tube.
2. Secure new heel loop to the footplate with the mounting screw, spacer and locknut.
Refer to FIGURE 5.3 for proper hardware orientation.
NOTE: When securing new heel loop to footrest assembly, tighten the mounting screw and locknut
until spacer is secure.
3. Secure the mounting tube and footrest to the footrest upper support as shown in
FIGURE 5.2.
4. Repeat STEPS 1-3 for opposite side, if necessary.
Part No 1088909
SECTION 5—FRONT RIGGINGS
Hex Screw
Coved Spacer
Footrest
FIGURE 5.2 - ADJUSTING
SWINGAWAY FOOTREST HEIGHT
31
Footrest
Upper
Support
Mounting
Tube
Patriot™