Using/Adjusting High Mount Wheel Locks (Push-To-Lock/Pull-To-Lock); Using High Mount Wheel Locks - Invacare Patriot Manuel De L'utilisateur Et D'entretien

3. Position the wheel lock shoe spacer
onto the wheel lock shoe.
4. Securely tighten set screws.
5. Adjust the wheel locks. Refer to
Adjusting Wheel Locks on page 52.
6. Repeat STEPS 1-4 for opposite side.
USING/ADJUSTING HIGH MOUNT WHEEL LOCKS
(PUSH-TO-LOCK/PULL-TO-LOCK)

USING HIGH MOUNT WHEEL LOCKS

DO NOT attempt to stop a moving wheelchair with the wheel locks, otherwise
injury or damage may occur. Wheel locks are NOT brakes.
NOTE: For this procedure, refer to FIGURE 9.6.
1. Ensure wheelchair is not moving before engaging.
2. Perform one (1) of the following:
A. Push-to-Lock - To engage, push the wheel lock handle FORWARD.
B. Pull-to-Lock - To engage, pull the wheel lock handle BACKWARD.
3. Disengage the wheel locks by reversing STEP 2.
Wheel Lock
FIGURE 9.6 - USING HIGH MOUNT WHEEL LOCKS
Part No 1088909
SECTION 9—ANTI-TIPPERS/WHEEL LOCKS
Wheel Lock
WARNING
PULL-TO-LOCK
53
Wheel Lock
Shoe
Set Screws
FIGURE 9.5 - INSTALLING WHEEL
LOCK SHOE SPACERS
PUSH-TO-LOCK
Wheel Lock
Shoe Spacer
Wedge End
Wheel Lock
Patriot™