Replacing The Wheel Locks; Replacing The High Mount Wheel Locks - Invacare PATRIOT Manuel D'entretien

WHEELS
2. Remove the mounting screw, coved spacers, cam
and locknut that secure the EXISTING cam to the
caster headtube.
3. Loosen the bottom mounting screw, coved spacers
and locknuts that secure the caster headtube to the
wheelchair frame.
NOTE: Loosening the bottom mounting screw allows
the cam to be positioned easily in the caster headtube.
4. Remove the cam from the wheelchair.
5. Install the NEW/EXISTING cam at the position noted
in STEP 1. Refer to FIGURES 3 OR 4 for correct
hardware orientation.
6. Securely tighten the bottom mounting screw, coved
spacers and locknuts that secure the caster headtube
to the wheelchair frame.

REPLACING THE WHEEL LOCKS

(FIGURE 5)
NOTE: BEFORE removing the wheel lock(s), note posi-
tion of wheel lock(s) on the wheelchair frame for proper
reinstallation.
1. Remove the mounting screw and washer that se-
cure the EXISTING wheel lock to the wheelchair frame.
2. Remove the EXISTING wheel lock from the wheelchair.
3. Install the NEW wheel lock to the wheelchair frame.
4. Secure the NEW wheel lock to the wheelchair frame
with the mounting screw and washer.
5. Repeat STEPS 1-4 for opposite side, if necessary.
6. Adjust the wheel locks. Refer to USING/ADJUST-
ING THE PATIENT OPERATED WHEEL LOCKS
in PROCEDURE 7 of the Owner's Manual, part num-
ber 1088909.
Washer
Mounting
Screw
Wheelchair Frame
FIGURE 5 - REPLACING THE WHEEL LOCKS
REPLACING THE HIGH MOUNT
WHEEL LOCKS (FIGURE 6)
NOTE: When using the 24-inch rear wheels the high mount
wheel lock will rest directly under the front arm socket.
NOTE: Note the position and orentation of the high mount
wheel locks and mounting hardware before removing.
1. Remove the two EXISTING (2) socket screws
2. Position the NEW clamps around the wheelchair
3. Loosely tighten the two (2) NEW socket screws
4. Slide the NEW wheel lock assembly into the
5. Adjust the wheel locks. Refer to WHEEL LOCK AD-
Wheel Lock
FIGURE 6 - REPLACING THE HIGH MOUNT
15
the secure the EXISTING clamps and wheel lock
assembly to the wheel chair frame and discard.
frame as shown in FIGURE 6.
that secure the NEW clamps to the wheelchair
frame.
clamps as shown in FIGURE 6.
JUSTMENT in PROCEDURE 7 of the Owner's
Manual, part number 1088233.
Socket Screws
Wheel
Lock
WHEEL LOCKS
PROCEDURE 5
W
H
E
E
L
S
Clamps
Wheelchair
Frame