Removing/Installing Front Arm Socket/Seat Guide - Invacare PATRIOT Manuel D'entretien

PROCEDURE 3
This Procedure Includes the Following:

Removing/Installing Front Arm Socket/Seat Guide

After ANY adjustments, repair or service
and BEFORE use, make sure all attaching
hardware is tightened securely - other-
A
wise injury or damage may occur.
R
M
REMOVING/INSTALLING FRONT
S
ARM SOCKET/SEAT GUIDE
(FIGURE 1)
Removing
1. Remove the front armrest from the front arm socket/
seat guide. Refer to ADJUSTING/USING ARM-
REST in PROCEDURE 4 of the Owner's Manual,
part number 1088909.
2. Lift up on the crossbraces to remove the crossbraces
from the seat guides.
3. Remove the mounting screw and locknut that secure
the EXISTING front arm socket/seat guide to the
wheelchair frame.
4. Remove the EXISTING front arm socket/seat guide
from the wheelchair.
5. Repeat STEPS 1-4 for opposite side, if necessary.
6. Install the NEW front arm socket/seat guide onto the
wheelchair. Refer to INSTALLING FRONT ARM
SOCKET/SEAT GUIDE in this procedure of the
manual.
WARNING
Installing
1. Install the NEW front arm socket/seat guide as shown
in FIGURE 1.
2. Install the EXISTING mounting screw through the front
arm socket/seat guide.
3. Install the locknut onto the mounting screw. Securely
tighten.
4. Repeat STEPS 1-3 for opposite side, if necessary.
5. Push down on the crossbraces to install the crossbraces
into the seat guides.
6. Reinstall the front armrest into the front arm socket/
seat guide. Refer to ADJUSTING/USING ARM-
REST in PROCEDURE 4 of the Owner's Manual,
part number 1088909.
Front Arm Socket/
Seat Guide
Mounting Screw
Outside of
Wheelchair
Frame
NOTE: Crossbraces NOT shown for clarity.
FIGURE 1 - REMOVING/INSTALLING
FRONT ARM SOCKET/SEAT GUIDE
8
ARMS
Locknut