Table des Matières
Publicité
5.14.3 One-arm drive
PAGE VOLONTAIREMENT BLANCHE
The quick release one-arm drive allows the user to
propel the wheelchair with one hand. Two hand rims
are mounted on the same rear wheel. The one-arm
drive wheel can be mounted on either the left or the
right side.
1a. Detaching the wheel
Pull the knob (A) and remove the wheel from the
hub.
1b. Attaching the wheel
Pull the knob (A) and push the wheel back onto
the hub.
It is very important that you check
that the locking pin has actually
locked the wheel into position when
the knob has been released. Take
hold of the wheels and try to detach
them. This should NOT be possible.
The hand rims can be positioned either level with each
other (internal position) or with the inner, smaller
hand rim protruding slightly (external position).
A
B
2. Changing the position of the hand rims
Unscrew the three screws (B), remove the hand rim
and turn it over. Put it back into position and firmly
retighten the three screws.
Take care when removing the teles-
copic transmission shaft. Point it away
from the body when releasing the
powerful spring.
Please note! The transmission shaft (C) is an integral
part of the wheelchair and the user will be unable to
propel the wheelchair without it.
Take care not to trap your fingers between the
spokes and the three bars of the outer handrim
(D).
5.14.4 Anti-tip device for one-arm drive
B
For information about usage and safety, read the page
about anti-tip devices in this manual.
Mounting
1. Attach the adapter plate to the anti-tip device with
the screws (A) using a 5 mm Allen key.
2. Attach the anti-tip device with adapter plate to the
rear wheel attachment with the screws and washers
(B) using a 4 mm Allen Key.
C
D
A
Publicité
Table des Matières
