Adjusting Anti-Tippers - Invacare Patriot Manuel De L'utilisateur Et D'entretien

SECTION 9—ANTI-TIPPERS/WHEEL LOCKS
3. If the distance between the bottom of
anti-tipper wheels and the ground/
floor is not 1½ to 2-inches, adjust anti-
tippers. Refer to - Installing Anti-
Tippers on page 50.

ADJUSTING ANTI-TIPPERS

NOTE: Refer to the charts in this procedure of
the manual before proceeding.
NOTE: For this procedure, refer to FIGURE
9.2.
1. Press the release buttons on the
wheeled portion of the anti-tipper and
slide it up or down to achieve the 1½ to
2-inch clearance.
2. Check to make sure that the release
buttons are fully engaged in
adjustment holes.
ANTI-TIPPER CHARTS
NOTE: Refer to the following charts to ensure the correct anti-tipper is installed in the wheelchair.
Seat-to-floor heights are approximate depending on front caster size and type. Anti-tipper length
measurement is taken with the extension tube in the longest position available.The anti-tipper
height measurement MUST be taken with the anti-tipper on a flat surface.
Patriot™
FIGURE 9.1 - INSTALLING ANTI-
FIGURE 9.2 - - INSTALLING ANTI-
Anti-tipper Height
Anti-tipper Length
50
Rear Frame Tubing
Release
Buttons
Anti-Tipper
Anti-Tipper Wheel
TIPPERS
Wheelchair Frame
Release
Buttons
1½ to 2 inch
Clearance
TIPPERS
Part No 1088909