Installing/Removing Seat Positioning Strap - Invacare Patriot Manuel De L'utilisateur Et D'entretien

SECTION 7—SEAT/BACK
INSTALLING/REMOVING SEAT POSITIONING
STRAP
NOTE: For this procedure, refer to FIGURE 7.4.
1. Remove seat cushion from wheelchair, if necessary.
2. Remove the rearmost mounting screw and washer that secures the seat upholstery to
the crossbrace as shown in FIGURE 7.4.
3. Grasp the rear edge of the seat upholstery and lift up to expose the rearmost mounting
hole in crossbrace.
4. Repeat STEPS 2-3 for opposite side, if necessary.
5. Do one (1) of the following:
A. To install the seat positioning strap, proceed to STEP 6.
B. Remove the existing seat positioning strap from the wheelchair.
6. Engage the two (2) halves of the new seat positioning strap.
7. Position one (1) end of the new seat positioning strap between the seat upholstery and
the crossbrace.
8. Align the mounting holes on the seat upholstery, crossbrace, and one (1) end of the
new seat positioning strap.
9. Secure the new seat positioning strap and seat upholstery to the crossbrace with one
(1) mounting screw and washer. Tighten securely.
10. Repeat STEPS 7-9 for opposite side of the seat positioning strap.
11. Reinstall seat cushion onto wheelchair, if necessary.
Rearmost Mounting Screw
Washer
CrossBrace
NOTE: Only hook and loop style seat positioning strap shown.
Auto style seat positioning strap attaches the same way.
FIGURE 7.4 - INSTALLING/REMOVING SEAT POSITIONING STRAP
Patriot™
Seat Positioning Strap Half
42
Part No 1088909