Commissioning; First Start-Up - Sanremo F18 Livret D'instructions

F18
8

COMMISSIONING

8.1 FIRST START-UP

IMPORTANT: the machine must
be started up for the first time
by a specialised authorised
technician.
- Open the water supply tap upstream of the
machine.
- Open the steam tap turning the knob (1)
counter-clockwise.
- Power up the machine by placing the differential
circuit breaker upstream of the machine in the
ON position.
- Turning the general switch (2) in the "1" position,
the indicator light (3) illuminates indicating
that circuit is live, the displays light up and the
automatic filling program shown on the display
starts (4).
If automatic filling does not
EN
take place within 90 seconds,
the machine stops and the
LEDs above the unit button
panels light up and flash.
Turn the machine on and off to
complete the water intake in
the boiler.
- When the boiler level indicator on the display
(4) stops flashing and the pump turn off, Turn
the general switch (2) in the "2" position and wait
for the heating of the machine.
- Wait until air mixed with water comes out of the
steam dispenser, then close the steam tap that
was previously opened.
- Dispense water from the units, without fitting the
filter holders, by pressing the buttons (5), (6),
(7), (8), (9) located on the front button panels,
checking that water comes out properly, venting
any air bubble present in the circuit.
- Press the same button again to stop dispensing.
- Wait for the set steam temperature (122°C)
and coffee water temperature (93°C) to be

Commissioning

reached, indicated on the display (4) and (12)
respectively. On the display (4), check that boiler
pressure is about 1 - 1.2 bars (0.1 - 0.12 MPa)
and that the mains water pressure does not
exceed 6 bars (0.6 MPa).
3
1
2
14
- Position a jug with handle under dispenser (13)
and dispense water by pressing button (11),
checking that dispensing is correct; dispensing
will stop automatically when the quantity set in
the program is reached.
- Position a jug of water and insert the wand (14)
into it. Open the steam tap by turning knob (1)
and try to heat water up.
Repeat the same operation with the other
dispenser on the other side of the machine.
- Attach the portafilters (9) to the group heads,
position the cups underneath and perform a few
deliveries, enabling the three brewing settings
using the corresponding buttons (10).
90
5
6
7
8
9
12 10
11
4
13