Sanremo F18 Livret D'instructions page 106

F18
The upper zone of display shows the selected
group. To modify the temperature press the button
"+" or "-" and press the button "√" to confirm;
move to the next screen to set the temperature of
following group by pressing the button ">".
Press the button "←" to return to the main
programming screen.
Programming pre-infusion
Press button (9) to display the following screen:
It is possible to enable or disable the pre-infusion
function by pressing the buttons "+" or "-". Press the
button "√" to confirm.
If pre-infusion is enabled the display shows the
EN
following screen:
It is possible to modify the length of preinfusion for
all buttons by pressing "+" or "-". Press the button
"√" to confirm.
Press the button""←" to return to the main
programming screen.
IMPORTANT: It is not possible
to activate the pre infusion on
the button "E".
Programming
Fine tuning doses
Press button (10) to display the following screen:
The display shows the quantity of coffee in ml. set
for selected dose, to modify the value press the
buttons "+" or "-". Press the button "√" to confirm
then press the button ">" to set the following
doses. Press the button""←" to return to the main
programming screen.
Autosteamer function (optional)
The autosteamer allows to froth the milk with a
temperature control and air compressor assembled
into the steam wand.
Press button (13) to display the following screen:
Press the button "+" or "-" to modify the type of
activation of the autosteamer wand button:
- frothed milk: to froth milk with foam
- hot milk : to heat up milk with steam (no foam)
- cleaning cycle: the machine will clean the steam
wand with erogation of hot water and steam. A
cleaning cycle must be performed after use of
steam wand with milk.
Press the button "√" to confirm, then press "←"
button to exit to the programming page.
106