Group On/ Off; Alarms - Sanremo F18 Livret D'instructions

the autosteamer wand will heat and froth the milk
to a specific programmed temperature. To program
this temperature proceed as follows:
- Press button "E" for at least 5 seconds until the
button turns on flashing.
- Put the desired quantity of milk in the jug,
submerge the steam wand into the milk and
activate the steam button (F).
- Insert a thermometer into the jug if you want to
control the desired milk temperature.
- Press again the steam button when milk reaches
the desired temperature.
- Wait 30 seconds to quit the programming stage.
- The programmed temperature is set.
Quit the programming stage
Press button (11) to quit the programming stage
and return to the main display screen.
Move to the previous/next page
Press button (12) to switch the programming
pages.
Programming
F

GROUP ON/ OFF

12
Heating of one or more groups can be set to be on
or off.
If you want to turn heating of one group off, press
buttons (E) and (C) at the same time, for the
correspondent group.
When the group is off, the display shows the
following screen:
To turn the heating back on, press buttons (E) and
(C) at the same time again.

13 ALARMS

No coffee/water delivered by group
- If the group does not deliver coffee or (with the
portafilter removed) water, the selected button
flashes to indicate the alarm.
Machine in standby
- If the machine accidentally switches to standby
mode, the display goes off and the button (C) of
the first left hand group flashes.
- To exit standby, press button (C) and the
machine comes on again.
Filling alarm
- If the machine detects anomalies with filling or
topping up the boiler with water, 120 seconds
after the start of filling, an alarm is triggered and
the steam boiler fill scale flashes on the general
display.
- To reset the alarm, turn off the machine and
check the water supply circuit. When the water
supply has been restored, the alarm resets
automatically.
107
F18
off
EN