Unold SOFTI Notice D'utilisation page 31

cooling container beforehand! The ingredients can freeze onto the edge of the
container and the desired soft ice cream result will not be achieved. Only fill
the ingredients through the filling shaft, when the appliance is switched on.
11. Plug the power cord into an electrical outlet.
12. Switch on the appliance by turning the rotary knob to "EIN" ("On").
13. Ensure that the discharge unit is closed, so that ice cream cannot flow out.
14. Remove the desired ice cream mixture from the refrigerator.
15. Fill the ice cream mixture into the appliance through the filling shaft.
16. Ensure that you fill the cooling container to 4 cm under the upper edge,
because the ice cream mixture expands in volume when it freezes.
17. The preparation time is approx. 15 to 30 minutes, depending on the ingre-
dients used, the temperature of the ingredients, exterior temperature, etc.
Check from time to time whether the mixture has reached the consistency
that you desire. Soft ice cream should have a creamy, light, airy consistency.
18. Caution: Do not switch off the appliance while it is making ice cream. This
would cause the ice cream mixture to freeze to the edge of the cooling con-
tainer. If the motor should overheat when ice cream is being prepared, the
motor switches off. In this case, place the "EIN/AUS" ("ON/OFF") switch
on "EIN" ("OFF"), unplug the power plug and allow the appliance to cool.
If you want to continue preparing ice cream, it may be necessary to use new
ice cream ingredients. In this case the ice cream should be removed from
the cooling container with a plastic spatula, not through the discharge open-
ing!
19. When the ice cream is ready, place a suitable container under the discharge
valve.
20. Slide the lever of the discharge valve to „Open" and let the ice flow into the
container. Important: Do not switch off the ice cream machine when ice cream
is flowing out of the discharge valve! There is a feed screw on the mixer that
conveys the ice cream downward through the discharge valve.
21. When all the ice cream has been removed, switch off the appliance and
unplug it from the electrical outlet.
22. Tip: If the ice cream is too solid, and cannot be removed via the discharge
valve, switch off the appliance, unplug the power plug and remove the ice
cream from the ice cream container with a plastic spatula.
Stand 20.2.2020
Copyright UNOLD AG | www.unold.de
DE
EN
FR
NL
IT
ES
PL
31 von 104