Cleaning And Sterilization Of The Torque Wrench - Mectron COMPACT PIEZO LED Mode D'emploi Et D'entretien

COMPACT PIEZO LED
Individually seal the inserts in single-use
sterilization packets.
Sterilize the inserts in a steam autoclave.
EN
STERILIZATION METHOD - Inserts
The sterilization process in steam autoclave
must be performed setting the parameters
indicated below, which are validated by
Mectron and reach the sterilization safety
levels (SAL 10
-6
- 3 times Pre-vacuum
(minimum pressure 60 mBar).
- Sterilization temperature 132°C
(interval 0°C ÷ +3°C).
- Sterilization time 4 minutes.
- Minimum drying time 20 minutes.
All the sterilization phases must be performed
by the operator in compliance to the norms
UNI EN ISO 17665-1:2007, UNI EN ISO
556-1:2002 e ANSI/AAMI ST46:2002.
06.3 Û CLEANING AND STERILIZATION OF THE TORQUE WRENCH
PREPARATION
- Take the wrench.
MATERIALS NECESSARY
- Enzymatic detergent with pH 6-9
- Water
- Ultrasound tank
- Brush with soft nylon bristles
- Distilled water
- Clean and soft cloth with low fiber-release
- Medical degree lubricant
- Single-use sterilization packets
- Steam sterilization
18
):
8
CAUTION: Do not sterilize the insert
screwed onto the handpiece.
WARNING: Checking infections - Parts
that can be sterilized - Diligently remove
all residues of organic dirt before the
sterilization.
CAUTION: Perform the sterilization
using a water steam autoclave only. Do not
use any other sterilization procedure (dry
heat, irradiation, ethylene oxide, gas, low
temperature plasma, etc.).
CAUTION: Do not exceed the allowed
load of the steam sterilizer.
CAUTION: Do not use hydrogen
peroxide. If you intend to disinfect the
wrench, do not use hydrogen peroxide, but
only disinfectants with neutral pH (pH7);
always rinse with sterile water to preserve
the disinfection.
CAUTION: Once used, correctly dispose
of the enzymatic detergent solution, do
not recycle.