Maintenance; Disposal Modes And Precautions; Û Disposal Modes And Precautions; Technical Data - Mectron COMPACT PIEZO LED Mode D'emploi Et D'entretien

07 Û MAINTENANCE
If the device is not used for prolonged time,
observe the following recommendations:
1 Before carrying on any kind of maintenace
activity make sure that the device is not
active;
2 Prior to using the device again, clean and
sterilize the handpiece, the inserts and
the wrench following the instructions
provided in Chapter 06 - CLEANING AND
STERILIZATION;
08 Û DISPOSAL MODES AND PRECAUTIONS
WARNING: Hospital wastes.
Hospital wastes. Treat the following items
as hospital waste:
- Inserts: when they are worn out or
broken;
- Torque wrench for inserts: when worn
out or broken.
The use and throw-away materials and
materials that entail a biological risk must
09 Û TECHNICAL DATA
Device compliant to Dir. 93/42/CEE:
Classification as per EN 60601-1:
Device for intermittent operation:
Power supply voltage:
Max. power absorbed:
Operating frequency:
Power types:
Water supply:
LED system of the handpiece:
07 Û MAINTENANCE
3 Check that the inserts are not worn out,
deformed, or broken, placing special
attention to the integrity of their tip
WARNING: Periodically check that
the scaler cord is intact; if it is damaged,
contact the dental chair manufacturer in
order to replace it with an original Mectron
spare part.
be disposed of in accordance to the norms in
force locally concerning hospital wastes.
compact piezo LED must be disposed of and
treated as a waste for separate collection.
Disregard of the previous points may entail a
fine, pursuant to Directive 2002/96/CE.
It is up to the purchaser to hand over the
device for its disposal to the retailer who
supplies him new equipment; the instructions
for proper disposal are available from Mectron.
Class IIa
The class definition is delegated to the dental chair
manufacturer using the compact piezo LED in its unit
Applied part type "B" (handpiece, insert)
IP According to the dental chair manufacturer
60sec. ON - 30sec. OFF with irrigation
30sec. ON - 120sec. OFF without irrigation
Power supply compliant to IEC/EN 60601-1:
24V 50/60 Hz, or
32V
40 VA
Automatic scan
From 24 KHz a 36 KHz
Adjustable according to the instructions given by the
dental chair manufacturer
Adjustable according to the instructions given by the
dental chair manufacturer
Operating pressure from 1 to 6 bar
Adjustable according to the instructions given by the
dental chair manufacturer
EN
21