Labeling An Md - Sony MDX-C800REC Mode D'emploi

Labeling an MD

You can label your recorded MDs and tracks.
You can enter up to 1,700 characters for labels
per disc (disc title and track title included).
Caution
Do not perform this procedure while driving,
as it diverts your attention from the road.
Note
Repeat play, shuffle play, and program play will be
suspended until the name edit mode is over.
Labeling a track
1
While playing the MD you want to edit,
press (MENU).
2
Press either side of (DISC/PRST)
repeatedly until "Name Edit" appears.
3
Press (ENTER).
4
While "Track" is flashing, press (ENTER)
to select track name edit.
5
Press either side of (SEEK/AMS)
repeatedly to select the track you want
to label.
6
Press (ENTER).
The unit will repeat the track during the
labeling procedure.
Selected track No.
7
Enter the characters.
1 Press the (+) side of (DISC/PRST) to
select desired characters.
t A t B t C t ... x t y t z
... # T " T ! T ... 2 T 1 T 0 T
If you press the (–) side of (DISC/PRST)
repeatedly, the characters will appear in
reverse order.
Each time you press (DSPL), the
character type changes as follows:
A t a t 0 t A
If you want to put a blank space
between characters, select "
2 Press the (+) side of (SEEK/AMS) after
locating a desired character.
If you press the (–) side of (SEEK/AMS),
you can move back to the left.
3 Repeat steps 1 and 2 to enter the
entire title.
8
Press (ENTER).
"Complete!" appears, and the selected title
is registered.
9
Press (MENU) twice.
To cancel the labeling procedure, press
(MENU) twice anywhere before step 8.
Labeling an MD
After step 3, press the (–) side of (SEEK/AMS)
to select disc name edit, and go to step 6.
The unit will repeat the disc during the
labeling procedure.
."
27