Getting Started; Installing The Unit And An Optional; Monitor; Resetting The Unit - Sony MEX-DV2200 Mode D'emploi

Getting Started

Installing the unit and an
optional monitor
Firstly, install and connect the unit and an
optional monitor.
This unit can be operated using the displays that
appear on the unit and/or the optional monitor.
Note that this manual includes instructions
concerning displays on both unit and/or optional

monitor.

Unit
For details, see the supplied installation/
connections manual.
Note
Be sure to install the optional monitor safely, and in a
place where it does not obstruct the driver's view.

Resetting the unit

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel (page 15) and press the
RESET button (page 10) with a pointed object,
such as a ball-point pen.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
14
Optional monitor

Performing initial setup

OFF SOURCE
Control dial
After resetting, the display for initial speaker
setup appears.
Be sure to set correctly following the procedure
below to enjoy the various sound functions of
this unit.
To skip the initial setup, press (OFF)/
(SOURCE), or insert a disc.
Note
The initial setup display automatically changes to the
center speaker setup if no operation is performed for
30 seconds.
During setup procedure, it is canceled if no operation
is performed for 15 seconds.
1
Press the control dial in the initial
setup display.
2
Rotate the control dial to set the
center speaker connection status,
then press it.
Select "C ON" if the center speaker is
connected, or select "C OFF" if not.
3
Rotate the control dial to set the
subwoofer connection status, then
press it.
Select "SUB ON" if the subwoofer is
connected, or select "SUB OFF" if not.