Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating an iPod directly
— Passenger control
You can operate an iPod connected to the dock
connector directly.
1
During playback, press and hold
(MODE).
"MODE IPOD" appears and you will be able
to operate the iPod directly.
To change the display to clock
Press (DSPL).
To exit the passenger control
Press and hold (MODE).
Then "MODE AUDIO" will appear and the play
mode will change to "RESUMING."
Notes
• The volume can be adjusted only by the unit.
• If this mode is canceled, the repeat setting will be
turned off.
Other functions
Changing the sound settings
Adjusting the sound
characteristics — BAL/FAD/SUB
You can adjust the balance, fader, and subwoofer
volume.
1
Press the select button repeatedly
until "BAL," "FAD" or "SUB" appears.
The item changes as follows:
t MID*
t HI*
LOW*
1
1
BAL (left-right) t FAD (front-rear) t
SUB (subwoofer volume)*
*1 When EQ3 is activated (page 13).
*2 When the audio output is set to "SUB-OUT"
(page 14).
"ATT" is displayed at the lowest setting, and can
be adjusted up to 21 steps.
*3 When AUX source is activated (page 14).
2
Rotate the control dial to adjust the
selected item.
3
Press
(BACK).
The setting is complete and the display
returns to normal play/reception mode.
Customizing the equalizer curve
— EQ3
"CUSTOM" of EQ3 allows you to make your
own equalizer settings.
1
Select a source, then press (EQ3)
repeatedly to select "CUSTOM."
2
Press the select button repeatedly
until "LOW," "MID" or "HI" appears.
3
Rotate the control dial to adjust the
selected item.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 2 and 3 to adjust the equalizer
curve.
To restore the factory-set equalizer curve,
press and hold the select button before the
setting is complete.
4
Press
(BACK).
The setting is complete and the display
returns to normal play/reception mode.
Tip
Other equalizer types are also adjustable.
t
1
t AUX*
2
3
13
Publicité
Chapitres
Table des Matières
Dépannage
