EMAK RIDER EL63 Manuel D'utilisation page 71

PROBLEM
10. Unusual vibrations while working
If problems continue after having carried out these operations, contact your dealer.
WARNING!
Do not take on complicated repair work if you don't have the necessary equipment or the techni
knowledge. The warranty is automatically voided and the manufacturer is not held responsible if repairs are done
badly.
LIKELY CAUSE
– cutting deck not parallel to the ground
– blade cutting badly
– forward speed too high compared to height
of grass
– collector channel is blocked
– cutting deck full of grass
– blade unbalanced
– blade loose
– fixing bolts loose
SOLUTION
– realign the cutting deck to the ground (
6.3.12)
– Contact your dealer
– reduce forward speed and/or raise the cutting
deck ( 5.4.5)
– wait for the grass to dry
– remove the grass-catcher and empty
the collector channel ( 5.4.7)
– clean the cutting deck ( 5.4.10)
– Contact your dealer
– Contact your dealer
– check and tighten all the fixing bolts
of the engine and frame
cal
EN 33