Unpacking And Assembly - EMAK RIDER EL63 Manuel D'utilisation

3. UNPACKING AND ASSEMBLY

IMPORTANT
The machine is supplied without engine
oil or fuel. Before starting up the engine, fill with oil and fuel
following the instructions given in paragraph 5.3.3. and in the
engine manual.
For storage and transport reasons, some components of the
machine have to be assembled after their removal from the
packing. Final assembly is carried out by following these sim-
ple instructions.
3.1 UNPACKING
When unpacking the machine, take care to gather all the indi-
vidual parts, fittings and documentation.
NOTE
To avoid damaging the cutting deck
when getting the machine down from the pallet, take it to the
maximum height and be very careful.
The supply includes:
– the battery;
– bolts and screws, necessary for completing the assembly;
– a syringe for draining the engine oil.
In addition,
Elecrtic start models:
– a battery charger;
– 2 starter keys;
– a spare 10 A fuse, to be kept in case of necessity.
3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and straighten up the front
wheels.
1. fit the bellows (1) onto the column (2);
2. fit the steering wheel and its column (2) onto the protruding
shaft (3) and fasten it with the screws (4) and nuts (5) sup-
plied, using both holes on the shaft (3).
4
3
1
5
2
5
EN 9