Replacing A Fuse - EMAK RIDER EL63 Manuel D'utilisation

load-bearing part
of the frame on the
side of the wheel to
be changed;
2. using a screwdriv-
er, remove the
snap ring (1) and
the washer (2);
3. pull out the wheel.
IMPORTANT
Smear some waterproof grease on the
axle and after refitting the wheel, carefully refit the washer (2)
and the snap ring (1).
NOTE
If you have to replace one or both rear
wheels, make sure that any differences in their external
diameter does not exceed 8-10 mm; on the contrary, to pre-
vent an uneven cut it will be necessary to adjust the align-
ment of the cutting deck.
6.3.3 Replacing and repairing tyres
All puncture repairs or replacements will have to be carried out
by a tyre repair expert in accordance with the methods for the
kind of tyre used.
EN 28

6.3.4 Replacing a fuse

Electric start:
1
The electric system and the
electronic card are protect-
ed by a fuse. When it
blows the machine stops,
so in this case:
1. remove the engine
2
2. replace the fuse (2) with
3. remount the engine
The fuse capacity is indi-
cated on the fuse.
If you cannot find out why the fuse has blown, consult a
Licensed Service Centre.
Manual start:
The electric system and the card are not protected by any
fuses. If the safety system fails to work properly or there are
engine problems due to the electric system, contact a
Licensed Service Centre.
housing (1) using a
screwdriver;
another one with the
same capacity;
housing (1).
IMPORTANT
A blown fuse must always be
replaced by one of the same type and ampere rating, and
never with one of another rating.
1
2