Interventions On The Machine; Replacing Wheels - EMAK RIDER EL63 Manuel D'utilisation

6.2.3 Battery
Electric start:
To ensure long life to the battery it is essential to keep it
carefully maintained.
The machine battery must always be charged:
– before using the machine for the first time after purchase;
– before leaving the machine for a prolonged period of dis-
use;
– before starting up the machine after a prolonged period
of disuse.
– To ensure long life to the battery it is essential to keep it
carefully maintained. Failure in following the procedure or
in charging the battery could permanently damage the
battery elements.
– A flat battery must be recharged as soon as possible.
IMPORTANT
Recharging must be done using a
battery charger at constant voltage. Other recharging
systems can irreversibly damage the battery.
The machine has a connector
(1) for recharging located next
to the battery, which is to be
connected to the correspon-
ding connector of the special
"CB02" maintenance battery
charger supplied.
IMPORTANT
This
connector must only be used
1
for connecting to the "CB02" maintenance battery charg-
er. For its use:
– follow the instructions given in the relative instructions
manual;
– follow the instructions given in the battery manual.

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven,
check the tyre pres-
sure.
If this is not suffi-
cient to achieve an
even cut, please
contact your Dealer
for the adjustment
of the alignment of
the cutting deck.

6.3.2 Replacing wheels

1. Place the machine on a flat surface and put blocks under a
EN 27