Preparing The Dräger Fps 7000 Rp For Use; Donning The Dräger Fps 7000 Rp; Checking Tight Fit - Dräger FPS 7000 RP Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Preparing the Dräger FPS 7000 RP for use
Install mask spectacles if necessary
If fitted, remove protective film from visor.
Soak the wiper with anti-fog agent "klar pilot" comfort. Apply the
anti-fog agent on the inside of the visor.
Do not operate wiper in dry condition.
If the Dräger FPS 7000 RP is equipped with a drinking valve, make
sure that the protective cap is located on the drinking valve. Alterna-
tively, the drinking tube can already be connected to the drinking valve.
NOTICE
If the drinking valve is not used at all during operation, the mouth-
piece should be removed in order to increase the wearing comfort
for the user.
Loosen the head harness as far as possible.
Lay the carrying strap around the neck and fasten the Dräger
FPS 7000 RP in the standby position using the carrying strap
(Figure B on Page 3).
1)
Strictly follow the corresponding assembly instructions.
134
1)
.
Donning the Dräger FPS 7000 RP
Loosen the Dräger FPS 7000 RP from the standby position.
Pull the head harness apart, then put your chin into chin cup of the
facepiece body (Figure C on Page 3).
Pull the head harness over your head and draw backwards.
Adjust the facepiece.
Pull the straps of the head harness until evenly tightened; first the
neck straps, then the temple straps, finally the harness connecting
piece (Figure D on Page 3).
Don the helmet and make sure that it fits correctly.
Don the closed-circuit breathing apparatus and connect the
Dräger FPS 7000 RP to the closed-circuit breathing apparatus
Lock the plug-in coupling into the connection piece.

Checking tight fit

Press both breathing hoses of the closed-circuit breathing
apparatus tightly together and inhale until negative pressure is
generated in the facepiece.
Hold your breath for a moment.
If the negative pressure is not maintained, pull the head harness
tighter.
Repeat the test twice.
Make sure that the Dräger FPS 7000 RP is airtight before reporting
to duty!
If the Dräger FPS 7000 RP leaks, there is danger of asphyxiation!
2)
Strictly follow the corresponding Instructions for Use.
Use Instructions for NIOSH-approved full facepieces
WARNING
2)
:

Publicité

Table des Matières
loading

Table des Matières