Instructions For Use - Dräger Oxy 3000 MK III Notice D'utilisation

1 For your safety
1.1 General safety instructions
 Before using this product, carefully read the instructions for use.
Strictly follow the instructions for use. The user must fully understand and

strictly observe the instructions. Use the product only for the purposes
specified in the intended use section of this document.
 Do not dispose of the instructions for use. Ensure that they are retained and
appropriately used by the product user.
 Only trained and competent users are permitted to use this product.
 Comply with all local and national rules and regulations associated with this
product.
 The oxygen self-rescuer is maintenance-free. However, it must be checked
regularly, see section 3.3 on page 8.
 Use only original Dräger parts and accessories. Otherwise, the proper
functioning of the product may be impaired.
 Do not use a faulty or incomplete product. Do not modify the product.
 Notify Dräger in the event of any product or component error or failure.
1.2 Definition of alert icons
The following alert icons are used in this document to provide and highlight areas
of the associated text that require a greater awareness by the user. A definition
of the meaning of each alert icon is provided below:
WARNING
!
Indicates a potentially hazardous situation.
If not avoided, it could result in death or serious injury.
CAUTION
!
Indicates a potentially hazardous situation. If not avoided it could
result in physical injury or damage to the product or the environment.
It may also be used to alert against incorrect use.
NOTICE
i i
Indicates additional information on how to use the product.
2 Description
2.1 Product overview
2.1.1 Housing
1
2 3 4
6
1 Upper part of the housing
2 Opener with seal
3 Lower part of the housing
4 Tightening straps
5 Viewing window with moisture indicator (and optionally with heat indicator)
6 Shoulder harness
(not displayed: belt loops for fastening the oxygen self-rescuer to the belt)
7 Casing protector (optional)
8 Product label
Dräger Oxy 3000/6000 MK III
5
7 8
00100133.eps
2.1.2 Functional part with mouthpiece and nose clip
10
9
18
9 Mouthpiece
10 Neck strap
11 Nose clip
12 Heat exchanger
13 Breath hose
14 Starter
15 Breathing bag
16 KO cartridge
2
17 Goggles
18 Chest strap
2.2 Feature description
The Dräger Oxy 3000/6000 MK III is an oxygen self-rescuer with a closed-circuit
pendulum breathing system. It is independent of the ambient air. Chemically-
bound oxygen is used to recycle exhaled air. The oxygen source is potassium
superoxide (KO , type K oxygen self-rescuer).
2
The Dräger Oxy 3000 MK III has a nominal usage period of 30 minutes. The
Dräger Oxy 6000 MK III has a nominal usage period of 60 minutes. However, the
length of the usage period depends on the user's respiration.
When carrying the oxygen self-rescuer on a daily basis, it can either be hung
over the shoulder or carried on a belt. The oxygen self-rescuer can be stored in
a fixed location on a wall bracket.
2.3 Intended use
The oxygen self-rescuer is an emergency device intended for escape from areas
with smoke, toxic gases or oxygen deficiency.
2.4 Limitations of use
The oxygen self-rescuer must not be used in areas with positive pressure.
The oxygen self-rescuer can only be used within temperature classes T1, T2, T3
and T4 (see German directive VDE 0171 and/or international standard
IEC 60079). The maximum surface temperature of the oxygen self-rescuer at the
starter is below 135 °C.
Since the oxygen self-rescuer is equipped with a mouthpiece and spectacles, it
is only conditionally suitable for people who wear dentures and/or glasses.
Suitability can be determined with the help of a training device.
2.5 Approvals
The oxygen self-rescuer is approved according to:
 DIN EN 13 794:2002
 (EU) 2016/425
 MDG 3609:2010
Declaration of conformity: see www.draeger.com/product-certificates
For your safety
11
12
13
14
15
16
17
00200133.eps
7